The short version of Ac-SDKP fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-01-06. Anything still debated is marked as such rather than presented as settled.
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
Identity and purity are assessed with a small set of standard techniques. Reverse-phase high-performance liquid chromatography gives a purity estimate from peak area, usually recorded at 214 or 220 nanometers, where the peptide bond absorbs. Mass spectrometry confirms the expected molecular mass and can reveal truncated or oxidized species. Amino acid analysis or tandem mass spectrometry sequencing can verify the sequence itself. Additional quality attributes include water content, residual trifluoroacetic acid carried over from purification, and endotoxin where the material is intended for biological work.
Thymosin beta-4 was isolated from calf thymus in the early 1980s and later characterised as an abundant intracellular actin-sequestering protein. Interest in short synthetic fragments grew once the actin-binding motif had been mapped to the middle of the sequence. TB-500 came out of that line of work as a truncated analogue rather than a natural isolate, and it is now sold mainly to laboratories. Published studies on the fragment have been largely in vitro or in animal models, and controlled human trials remain sparse, so claims about effects in people rest on extrapolation.
Literature and online discussion often conflate TB-500 with full-length thymosin beta-4, even though the two differ in size and are not interchangeable in analytical terms. The fragment is produced by solid-phase peptide synthesis, and the product is a defined seven-residue chain rather than a biological extract. Because the term is a trade-style label, two vendors may supply materials of the same nominal sequence but different counter-ion content, purity, or water content. Comparisons across studies are therefore difficult unless the exact sequence and purity are reported.
TB-500 is a research peptide whose sequence matches residues 17 to 23 of thymosin beta-4, a 43-residue protein present in most mammalian cells. The chain is seven amino acids long, written as LKKTETQ, and is normally supplied with an acetyl group on the N-terminus. Suppliers list it as a lyophilised powder under the code name TB-500, and the same sequence appears elsewhere in catalogues as the thymosin beta-4 actin-binding fragment. The label is commercial rather than systematic, so no single authority fixes exactly what TB-500 denotes.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white powder | Lyophilized cake or fluffy solid |
| Water solubility | High | Dissolves in water and neutral buffers |
| Dry storage | -20 °C or below | Dry, dark, desiccated |
| Reconstituted storage | Frozen, single thaw | Repeated freeze-thaw promotes loss |
| Purity method | Reverse-phase HPLC | Peak area read at 214 or 220 nm |
TB-500 is a catalogue name applied to a synthetic peptide related to thymosin beta-4, an actin-binding protein found in most mammalian cells. Suppliers do not use the label consistently: some describe it as the full 43-residue protein, others as a short fragment from the actin-binding region, and others as a related tetrapeptide. Because the name is commercial rather than chemical, two products sold under it may not contain the same molecule. This naming ambiguity is the first point to check in any description of the material.
The most frequently cited identity is a seven-residue fragment with the sequence LKKTETQ, taken from the actin-binding domain of the parent protein. A separate molecule, N-acetyl-seryl-aspartyl-lysyl-proline, often shortened to Ac-SDKP, derives from the same protein's N-terminal region and appears in overlapping literature. Reported molecular masses therefore differ between sources, and a mass value on its own does not establish which fragment is present. Confirmation requires a defined sequence rather than a single number.
Research interest in thymosin beta-4 fragments centres on actin sequestration, cell migration and tissue repair models. Most published work uses cultured cells or animal wound and cardiac preparations, and findings are generally described as preliminary. No fragment of this protein has been approved as a therapeutic product by major regulators. Reviews of the field note inconsistent dosing, delivery routes and outcome measures across studies, which complicates direct comparison. The material is best understood as a laboratory reagent with an active but unresolved research literature.
Identity and purity are checked with chromatographic and mass spectrometric methods. Reverse-phase high-performance liquid chromatography separates the peptide from related impurities, while mass spectrometry confirms the expected molecular mass. A certificate of analysis may report a purity percentage, but the laboratory should still verify the material independently. Common quality concerns include truncated sequences, deamidation, oxidation, and residual solvents from synthesis. Because TB-500 is short, some impurities can differ from the target by only a few mass units.
Reconstitution practices affect downstream measurements. The dry powder is typically dissolved in sterile water or a suitable aqueous buffer, then mixed gently rather than vortexed at high speed. Visible particles or cloudiness suggest incomplete dissolution or contamination and should be investigated. For long-term storage, aliquots should be labeled with concentration, solvent, and date. Open questions include how different buffers alter peptide conformation and whether specific container materials adsorb the peptide. Those variables can change apparent concentration in assays even when the chemical identity is correct.
Lyophilized TB-500 is hygroscopic and should be kept dry before use. The usual storage recommendation for the solid is -20 °C, protected from light and moisture. Once dissolved, the peptide is less stable, and repeated freeze-thaw cycles can promote aggregation or degradation. Laboratories often divide a reconstituted solution into single-use aliquots and store them at -80 °C. Exact stability limits depend on buffer, pH, and concentration, so published data do not define a single universal condition.
=== Amino acid coupling reagents === An important feature that has enabled the broad application of SPPS is the generation of extremely high yields in the coupling step. In stepwise peptide synthesis by SPPS, highly efficient amide bond-formation conditions are required because all resin-bound peptide products are carried over into the final crude product released from the resin. To illustrate the impact of sub-optimal coupling yields for peptide synthesis, consider the case where each coupling step were to have at least 99% yield: this would result in a 77% overall crude yield for a 26-amino acid peptide (assuming 100% yield in each deprotection); if each coupling were 95% efficient, the overall yield would be 25%. In attempts to maximize coupling yields, often a large excess of each amino acid (between 2- and 10-fold) is used in each SPPS coupling reaction. The minimization of amino acid racemization during coupling is also of vital importance to avoid epimerization in the final peptide product. Amide bond formation between an amine and carboxylic acid requires 'coupling reagents' to activate the carboxyl group of the N-alpha protected amino acid reactant. A wide range of coupling reagents exist, due in part to their varying effectiveness for particular couplings, many of these reagents are commercially available.
A 2005 meta-analysis of drug company data found no evidence that SSRIs increased the risk of suicide; however, important protective or hazardous effects could not be excluded. A 2005 review observed that suicide attempts are increased in those who use SSRIs as compared to placebo and compared to therapeutic interventions other than tricyclic antidepressants. No difference risk of suicide attempts was detected between SSRIs versus tricyclic antidepressants. A 2006 review suggests that the widespread use of antidepressants in the new "SSRI-era" appears to have led to a highly significant decline in suicide rates in most countries with traditionally high baseline suicide rates. The decline is particularly striking for women who, compared with men, seek more help for depression. Recent clinical data on large samples in the US, too, have revealed a protective effect of antidepressants against suicide. A 2006 meta-analysis of randomized controlled trials suggests that SSRIs increase suicide ideation compared with placebo. However, the observational studies suggest that SSRIs did not increase suicide risk more than older antidepressants. The researchers stated that if SSRIs increase suicide risk in some patients, the number of additional deaths is small because ecological studies have generally found that suicide mortality has declined (or at least not increased) as SSRI use has increased. An additional meta-analysis by the FDA in 2006 found an age-related effect of SSRIs. Among adults younger than 25 years, results indicated that there was a higher risk for suicidal behavior.
== History == Results of a Phase I clinical trial were reported in 2016. In December 2019, enfortumab vedotin was approved in the United States for the treatment of adult patients with locally advanced or metastatic urothelial cancer who had previously received a programmed cell death receptor-1 (PD-1) or programmed death ligand 1 (PD-L1) inhibitor and a platinum-containing chemotherapy. The approval was based on the results of a clinical trial of 125 such patients. The overall response rate, reflecting the percentage of patients who had a certain amount of tumor shrinkage, was 44%; specifically, 12% had a complete response and 32% a partial response. The median duration of response was 7.6 months. The U.S. Food and Drug Administration (FDA) granted the application for enfortumab vedotin accelerated approval, priority review designation, and breakthrough therapy designation. The FDA granted the approval of Padcev to Astellas Pharma US Inc. In July 2021, the FDA approved enfortumab vedotin for adults with locally advanced or metastatic urothelial cancer who have previously received a PD-1 or PD-L1 inhibitor and platinum-containing chemotherapy, or who are ineligible for cisplatin-containing chemotherapy and have previously received therapy.
== Function == Acetolactate synthase is catalytic enzyme involved in the biosynthesis of various amino acids. This enzyme has the Enzyme Commission Code is 2.2.1.6, which means that the enzyme is a transketolase or a transaldolase, which is classified under the transferases that transfer aldehyde or ketone residues. In this case, acetolactate synthase is a transketolase, which moves back and forth, having both catabolic and anabolic forms. These act on a ketone (pyruvate) and can go back and forth in the metabolic chain. These are found in humans, animals, plants, and bacteria. In plants, they are located in the chloroplasts in order to help with the metabolic processes. In baker's yeast, they are located in the mitochondria. In several experiments, it has been shown that mutated strains of Escherichia coli K-12 without the enzyme were not able to grow in the presence of only acetate or oleate as the only carbon sources. A catabolic version that does not bind FAD (InterPro: IPR012782) is found in some bacteria.
Sources: en.wikipedia.org
Crocodiles are protected in many parts of the world, and are farmed commercially. Their hides are tanned and used to make leather goods such as shoes and handbags; crocodile meat is also considered a delicacy. The most commonly farmed species are the saltwater and Nile crocodiles. Farming has resulted in an increase in the saltwater crocodile population in Australia, as eggs are usually harvested from the wild, so landowners have an incentive to conserve their habitat. Crocodile leather is made into wallets, briefcases, purses, handbags, belts, hats, and shoes. Crocodile oil has been used for various purposes. Snakes are also farmed, primarily in East and Southeast Asia, and their production has become more intensive in the last decade. Snake farming has been troubling for conservation in the past as it can lead to overexploitation of wild snakes and their natural prey to supply the farms. However, farming snakes can limit the hunting of wild snakes, while reducing the slaughter of higher-order vertebrates like cows. The energy efficiency of snakes is higher than expected for carnivores, due to their ectothermy and low metabolism. Waste protein from the poultry and pig industries is used as feed in snake farms. Snake farms produce meat, snake skin, and antivenom. Turtle farming is another known but controversial practice. Turtles have been farmed for a variety of reasons, ranging from food to traditional medicine, the pet trade, and scientific conservation. Demand for turtle meat and medicinal products is one of the main threats to turtle conservation in Asia.
Any drug (including a biological product for human use), medical device for human use, human food additive, color additive, electronic product, or any other article subject to regulation under the FD&C Act (21CFR50.3) Toxicity
==== Coffee substitute ==== Roasted and ground soybeans can be a caffeine-free substitute for coffee. After the soybeans are roasted and ground, they look similar to regular coffee beans or can be used as a powder similar to instant coffee, with the aroma and flavor of roasted soybeans.
Sources: en.wikipedia.org
Short transit at ambient temperature is generally tolerated, but long-term storage at room temperature is not recommended. Heat, moisture, and light all accelerate degradation. Cold, dry, dark storage is the conventional choice.
Suppliers typically quote a percentage derived from reverse-phase HPLC peak area. That figure reflects the relative amount of the main peak and does not by itself confirm identity or exclude related impurities. Mass spectrometry is commonly paired with it for confirmation.
Peptides purified by reverse-phase chromatography often carry trifluoroacetate as a counter-ion, which adds mass and can affect solubility and apparent behavior in assays. Acetate and hydrochloride forms are also offered. Knowing which form is present matters when calculating how much peptide a given weight contains.
No. Thymosin beta-4 is a 43-residue protein, while TB-500 matches only residues 17 to 23 of that chain. The two are related but differ in size, and a method that identifies one does not automatically identify the other.