The short version of reverse-phase HPLC fits in a sentence. The long version — which is the one that helps — is below.
Reviewed 2026-06-10. Anything still debated is marked as such rather than presented as settled.
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Material sold under this label typically arrives as a freeze-dried powder in a sealed vial with a certificate of analysis. Such certificates usually report reversed-phase chromatography purity plus a mass confirmation, and stated purities commonly sit between 95 and 99 percent. Counter-ion identity, residual trifluoroacetate, water content, and peptide net weight are separate specifications that a certificate may or may not include. A purity figure alone does not establish sequence identity, so independent mass verification remains the practical check.
The compound is most often distributed as a lyophilized powder, appearing white to off-white and forming a loose cake or fluffy solid. It is hygroscopic to some degree, so brief exposure to humid air can add water weight and complicate weighing. The peptide dissolves readily in water and in neutral aqueous buffers, and aqueous solubility is generally described as high, well above the concentrations used in typical assays. Some polar organic solvents are also usable, which matters when a concentrated stock is prepared before dilution into buffer.
Storage recommendations center on keeping the dry powder cold, dry, and dark. A freezer at -20 degrees Celsius or below is conventional, and desiccant is often included to limit moisture uptake. Once dissolved, the peptide is less stable, and solutions are typically kept frozen and thawed only once. Repeated freeze-thaw cycles are a common source of losses because they promote aggregation and adsorption to container surfaces. Working aliquots are therefore prepared in advance, and glass or low-binding plastic is usually preferred over ordinary laboratory plastic.
| Property | Value | Notes |
|---|---|---|
| Molecular mass | ≈889 Da for the 7-residue fragment | Full-length thymosin beta-4 is ≈4.9 kDa; catalogs differ |
| Appearance | White to off-white powder | Hygroscopic; weight shifts with residual moisture |
| Solubility class | Freely soluble in water | Also dissolves in aqueous buffers; poorly soluble in nonpolar solvents |
| Typical storage temperature | −20 °C, desiccated, protected from light | Once rehydrated, short-term holding at 2-8 °C |
| Typical analytical method | Reversed-phase HPLC with mass spectrometry | Purity by UV absorbance; identity by ESI-MS or MALDI-TOF |
Full-length thymosin beta-4 consists of roughly forty-three amino acids and ranks among the more abundant small proteins in the cytoplasm. The fragment is much shorter, so it cannot reproduce every function attributed to the intact molecule. In cell culture, short actin-binding motifs can interfere with filament dynamics and cell movement, but such observations come from controlled experiments rather than from whole-animal work. Whether a truncated fragment produces the same effects as the parent protein remains an open question.
Interest in the peptide grew during the 2000s and 2010s, when studies of tendon and ligament injuries in horses reported changes in lesion size after treatment. Those reports circulated widely outside the scientific literature and shaped much of the current online discussion. Subsequent reviews noted inconsistent study design, small groups, and a shortage of independent replication. Popular descriptions often blur the line between the fragment, the complete protein, and unrelated growth factors, which complicates comparisons across sources.
Lyophilised peptide powders are hygroscopic, and the fragment absorbs atmospheric moisture when a vial is opened at room temperature. Weighing and aliquoting are normally done quickly in a dry environment, and stock solutions are divided into single-use portions before freezing. Repeated freeze-thaw cycles are avoided because they promote aggregation and can shift the measured content of a vial. These practices are general to synthetic peptides rather than unique to this sequence, but they matter more for short chains kept for long periods.
The seven-residue chain carries several polar and charged side chains, so it dissolves readily in water and in aqueous buffers near neutral pH. No cysteine is present, so disulphide formation is not a concern and reducing agents are unnecessary. Dilute ammonium hydroxide or acetonitrile-water mixtures are sometimes used for stock solutions when initial dissolution is slow. Strongly alkaline conditions and prolonged contact with oxidising agents are avoided because they can modify lysine-containing stretches, and haze in solution usually signals incomplete dissolution or aggregated material.
Identity and purity are checked with reversed-phase high-performance liquid chromatography, which separates the target sequence from truncated or deletion analogues, and with mass spectrometry, which confirms the expected molecular mass. Amino acid analysis and peptide mapping give orthogonal confirmation but are used less often outside specialist laboratories. Counter-ion content varies: material purified on trifluoroacetic acid gradients retains trifluoroacetate, and ion exchange can convert the salt form. Residual water and solvent are measured by Karl Fischer titration or thermogravimetric analysis, and any purity figure should be read together with the method used to obtain it.
Dry peptide powder is commonly kept at −20 °C in a desiccated container away from light, a practice that limits moisture uptake and oxidation. Once dissolved, solutions are generally held at 2–8 °C for short periods or frozen at −20 °C or lower for longer storage, with repeated freeze-thaw cycles avoided. Hydrolysis and oxidation are the main degradation routes for peptides in solution, and both accelerate at higher temperature or extreme pH. Published stability data specific to TB-500 are limited, so shelf life should be treated as uncertain.
Identity and purity checks for peptide material typically combine reversed-phase high-performance liquid chromatography with mass measurement, since retention time alone cannot confirm a sequence. Mass measurement verifies the expected molecular mass within instrument tolerance, while chromatographic peak area provides a purity estimate. Anti-doping analysis of urine uses related but more sensitive workflows, sometimes after solid-phase extraction. For research material, batch documentation, certificate content, and independent testing are common points of scrutiny, because supply chains outside pharmaceutical regulation vary widely in the paperwork they provide.
Reconstitution of a lyophilized peptide is normally done with sterile water or a suitable buffer under aseptic conditions. Adding solvent down the vial wall and allowing gentle dissolution instead of vigorous vortexing reduces the chance of aggregation, which can lower the effective concentration of the resulting solution. Concentrated stocks are usually diluted into working buffer shortly before use. Because no standard preparation protocol exists for TB-500 specifically, laboratories adapt general peptide handling practice, and reported results may reflect differing preparation choices.
Congress passed the Authorization for the use of Military Force Against Terrorists, which grants the President the authority to use all "necessary and appropriate force" against those whom he determined "planned, authorized, committed or aided" the September 11 attacks or who harbored said persons or groups. It is still in effect. On October 7, 2001, the war in Afghanistan began when U.S. and British forces initiated aerial bombing campaigns targeting Taliban and al-Qaeda camps, then later invaded Afghanistan with ground troops of the Special Forces. This eventually led to the overthrow of the Taliban's rule of Afghanistan with the Fall of Kandahar on December 7, by U.S.-led coalition forces.
Syngenta's azoxystrobin was the first product launched. BASF's F-500 Series, which includespyraclostrobin and kresoxim-methyl, and Bayer CropScience, and Monsanto are developing new compounds in this class. Combination pesticides, such as Monsanto's Genuity and SmartStax are more and more frequently used.
=== Ethylene vinyl alcohol co-polymer in dimethyl sulfoxide === 8% ethylene vinyl alcohol co-polymer in dimethyl sulfoxide solution has been used. For FI it is marketed as Onyx34, and for gastroesophageal reflux disease it is marketed as Enteryx. After injection, it forms a spongy solid mass via solidification of the hydrophobic copolymer. This occurs because the co-polymer is hydrophic, and the solvent is dissolved away upon contact with tissues. In one publication inter-sphincteric injection site was used via the inter-sphincteric route.
Sources: en.wikipedia.org
In such a situation the risk for another affected child is higher than in a genotypically normal parent. Type III collagen could also be important in several other human diseases. Increased amounts of type III collagen are found in many fibrotic conditions such as liver and kidney fibrosis, and systemic sclerosis. This has led to a search for serum biomarkers that could be used for diagnosing these conditions without having to obtain a tissue biopsy. The most widely used biomarker is the N-terminal propeptide of type III procollagen, which is cleaved off during the biosynthesis of type III collagen.
During the production of incandescent filaments, recrystallisation of tungsten is significantly lowered by adding small amounts of thorium dioxide to the tungsten sintering powder before drawing the filaments. A small addition of thorium to tungsten thermocathodes considerably reduces the work function of electrons; as a result, electrons are emitted at considerably lower temperatures. Thorium forms a one-atom-thick layer on the surface of tungsten. The work function from a thorium surface is lowered possibly because of the electric field on the interface between thorium and tungsten formed due to thorium's greater electropositivity. Since the 1920s, thoriated tungsten wires have been used in electronic tubes and in the cathodes and anticathodes of X-ray tubes and rectifiers. The reactivity of thorium with atmospheric oxygen required the introduction of an evaporated magnesium layer as a getter for impurities in the evacuated tubes, giving them their characteristic metallic inner coating. The introduction of transistors in the 1950s significantly diminished this use, but not entirely. Thorium dioxide is used in gas tungsten arc welding (GTAW) to increase the high-temperature strength of tungsten electrodes and improve arc stability. Thorium oxide is being replaced in this use with other oxides, such as those of zirconium, cerium, and lanthanum. Thorium dioxide is found in refractory ceramics, such as high-temperature laboratory crucibles, either as the primary ingredient or as an addition to zirconium dioxide.
Hypotension (low blood pressure) Dysphoria Tachycardia Malaise Psychomotor impairment It is not believed to be addictive but is known to produce mild withdrawal effects (e.g., anorexia) after abrupt discontinuation.
The government of Santiago Peña began on 15 August 2023 following his election as President of Paraguay. He was sworn in as president at the age of 44, becoming the youngest president of Paraguay since the restoration of democracy in 1989, surpassing Mario Abdo Benítez, who was 46 years old at the time of his inauguration. In the first days of his term, administrative reforms aimed at the reorganization of the executive branch and the centralization of state functions were promoted. One of the main changes was the creation of the Ministry of Economy and Finance, enacted on 23 August 2023. This new ministry absorbed the functions of the defunct Ministry of Finance, the Technical Secretariat for Economic and Social Development Planning (STP), and the Secretariat of the Civil Service (SFP). Carlos Fernández Valdovinos was appointed as the first minister of this institution. Likewise, the National Directorate of Tax Revenue (DNIT) was established through the merger of the Undersecretariat of State for Taxation (SET) and the National Customs Directorate (DNA). As for the binational entities and other key institutions, Justo Zacarías Irún was appointed acting general director of Itaipu Binacional, while Luis Federico Benítez Cuevas assumed office as acting director of the Yacyretá Binational Entity (EBY). At the National Development Bank (BNF), the presidency was assigned to Manuel Ochipinti. For her part, Liliana Alcaraz was appointed minister of the Secretariat for the Prevention of Money or Asset Laundering (Seprelad).
Sources: en.wikipedia.org
Usually not, though usage overlaps. The label most often refers to a short acetylated fragment of the parent protein, while thymosin beta-4 itself is the full 43-residue molecule. Because suppliers vary, a sequence statement is needed to settle the question for any particular lot.
The name is a commercial label rather than a systematic chemical designation, so different vendors and papers attach it to different sequences. Some treat it as a fragment and others as the whole protein. Comparing two reports therefore requires checking what each one actually analyzed.
Typically it reflects the relative area of the main peak in a reversed-phase chromatogram at a given wavelength. It does not confirm the amino acid sequence, the counter-ion, or the amount of peptide by mass. Identity is normally established by a separate mass measurement.
Short transit at ambient temperature is generally tolerated, but long-term storage at room temperature is not recommended. Heat, moisture, and light all accelerate degradation. Cold, dry, dark storage is the conventional choice.