TB-500 comes up often in conversation and rarely with the context attached. Here we lay out the basics in order, then work through the practical considerations.
Updated 2025-09-02. Numbers and descriptions here follow the published literature rather than marketing material.
TB-500 is a laboratory label applied to a short synthetic peptide that is widely described as a fragment of thymosin beta-4, an actin-binding protein present in most mammalian cells. Suppliers and review articles usually present TB-500 as the N-terminal region of that protein, but the exact sequence attached to the name is not consistent across sources. Some product descriptions list a seven-residue chain; others use the label loosely for the parent protein itself. Because of that variation, any technical discussion of TB-500 needs to state which sequence is meant.
Thymosin beta-4 contains 43 amino acids and has a reported molecular mass near 4963 Da. The short fragment most often associated with the TB-500 label, an acetylated chain beginning LKKTETQ, has a reported mass near 889 Da, so the two are easily separated in analytical work. Mass spectrometry and amino acid analysis can confirm which material is present in a given sample. Statements treating TB-500 and thymosin beta-4 as interchangeable are therefore imprecise, even though the two appear together in much of the same literature.
Material is normally supplied as a lyophilised powder in a sealed vial. The powder is hygroscopic, so exposure to humid air leads to water uptake, caking and gradual loss of the fluffy texture that indicates a good freeze-dry. Vials are best kept sealed with desiccant, protected from light and stored cold. Letting a cold vial warm to room temperature before opening reduces condensation on the contents. Purity is normally reported from a chromatographic run, and that figure applies to the batch as tested rather than to the vial after repeated opening.
Once dissolved, the peptide is far less stable than the dry powder. Aqueous solutions are subject to hydrolysis, oxidation at susceptible residues and gradual loss of material through adsorption onto glass and plastic surfaces. Terminal glutamine can cyclise under some conditions, producing a related species that complicates purity assessment. Dilute solutions tend to lose a larger fraction of material to surfaces than concentrated ones. Buffers, pH and ionic strength all influence the rate of change, so stability figures are only meaningful when those parameters are stated alongside the storage interval.
| Property | Value | Notes |
|---|---|---|
| Physical form | Lyophilised powder | Sealed vial; reconstituted before laboratory use |
| Appearance | White to off-white solid | Visual descriptor used on certificates of analysis |
| Solubility class | Water-soluble | Dissolves in water and aqueous buffers |
| Reported mass, fragment | Near 889 Da | Value depends on the stated sequence |
| Reported mass, parent protein | Near 4963 Da | 43-residue thymosin beta-4 |
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
=== Industrial === EDTA is mainly used to sequester (bind or confine) metal ions in aqueous solution. In the textile industry, it prevents metal ion impurities from modifying colours of dyed products. In the pulp and paper industry, EDTA inhibits the ability of metal ions, especially Mn2+, from catalysing the disproportionation of hydrogen peroxide, which is used in chlorine-free bleaching.
==== Inflammatory bowel disease ==== Vitamin D deficiency has been linked to the severity of inflammatory bowel disease (IBD). However, whether vitamin D deficiency causes IBD or is a consequence of the disease is not clear. Supplementation leads to improvements in scores for clinical inflammatory bowel disease activity and biochemical markers, and less frequent relapse of symptoms in IBD.
=== T cells === Some T cells (e.g. regulatory T cells) release TGF-β1 to inhibit the actions of other T cells. Specifically, TGF-β1 prevents the interleukin(IL)-1- & interleukin-2-dependent proliferation in activated T cells, as well as the activation of quiescent helper T cells and cytotoxic T cells. Similarly, TGF-β1 can inhibit the secretion and activity of many other cytokines including interferon-γ, tumor necrosis factor-alpha (TNF-α), and various interleukins. It can also decrease the expression levels of cytokine receptors, such as the IL-2 receptor to down-regulate the activity of immune cells. However, TGF-β1 can also increase the expression of certain cytokines in T cells and promote their proliferation, particularly if the cells are immature.
Sources: en.wikipedia.org
== Advantages == Ionization of the substrate is very efficient as it occurs at atmospheric pressure, and thus has a high collision frequency. Additionally, APCI considerably reduces the thermal decomposition of the analyte because of the rapid desolvation and vaporization of the droplets in the initial stages of the ionization. This combination of factors most typically results in the production of ions of the molecular species with fewer fragmentations than many other ionization methods, making it a soft ionization method. Another advantage to using APCI over other ionization methods is that it allows for the high flow rates typical of standard bore HPLC (0.2–2.0 mL/min) to be used directly, often without diverting the larger fraction of volume to waste. Additionally, APCI can often be performed in a modified ESI source. The ionization occurs in the gas phase, unlike ESI, where the ionization occurs in the liquid phase. A potential advantage of APCI is that it is possible to use a nonpolar solvent as a mobile phase solution, instead of a polar solvent, because the solvent and molecules of interest are converted to a gaseous state before reaching the corona discharge needle. Because APCI involves a gas-phase chemistry, there is no need to use special conditions such as solvents, conductivity, pH for LC. APCI appears to be more versatile LC/MS interface and more compatible with reversed-phase LC than ESI.
== External links == The MEROPS online database for peptidases and their inhibitors: S01.233 Archived 2019-09-13 at the Wayback Machine Plasmin at the U.S. National Library of Medicine Medical Subject Headings (MeSH) This article incorporates text from the United States National Library of Medicine, which is in the public domain.
==== Syria sanctions ==== Bush expanded economic sanctions on Syria. In 2003, Bush signed the Syria Accountability Act, which expanded sanctions on Syria. In early 2007, the Treasury Department, acting on a June 2005 executive order, froze American bank accounts of Syria's Higher Institute of Applied Science and Technology, Electronics Institute, and National Standards and Calibration Laboratory. Bush's order prohibits Americans from doing business with these institutions suspected of helping spread weapons of mass destruction and being supportive of terrorism. Under separate executive orders signed by Bush in 2004 and later 2007, the Treasury Department froze the assets of two Lebanese and two Syrians, accusing them of activities to "undermine the legitimate political process in Lebanon" in November 2007. Those designated included: Assaad Halim Hardan, a member of Lebanon's parliament and former leader of the Syrian Socialist National Party; Wi'am Wahhab, a former member of Lebanon's government (Minister of the Environment) under Prime Minister Omar Karami (2004–2005); Hafiz Makhluf, a colonel and senior official in the Syrian General Intelligence Directorate and a cousin of Syrian president Bashar al-Assad; and Muhammad Nasif Khayrbik, identified as a close adviser to Assad.
== Pharmacokinetics == Prucalopride is rapidly absorbed (Cmax attained 2–3 hours after single 2 mg oral dose) and is extensively distributed. Metabolism is not the major route of elimination. In vitro, human liver metabolism is very slow and only minor amounts of metabolites are found. A large fraction of the active substance is excreted unchanged (about 60% of the administered dose in urine and at least 6% in feces). Renal excretion of unchanged prucalopride involves both passive filtration and active secretion. Plasma clearance averages 317 ml/min, terminal half-life is 24–30 hours, and steady-state is reached within 3–4 days. On once daily treatment with 2 mg prucalopride, steady-state plasma concentrations fluctuate between trough and peak values of 2.5 and 7 ng/ml, respectively. In vitro data indicate that prucalopride has a low interaction potential, and therapeutic concentrations of prucalopride are not expected to affect the CYP-mediated metabolism of co-medicated medicinal products.
Sources: en.wikipedia.org
No. TB-500 is a trade-style label used for a synthetic peptide described as a fragment of thymosin beta-4, while thymosin beta-4 is the full 43-residue protein. The two differ in size and are not interchangeable terms in analytical work.
Naming for research peptides is not standardised, and suppliers sometimes apply the same label to different chain lengths. Certificates of analysis and mass data are the practical way to determine what a given lot contains.
The fragment commonly cited under this label is reported near 889 Da, and the parent protein near 4963 Da. Reported values shift with the exact sequence and with residual counter-ions or water in the sample.
Sealed, dry and protected from light at reduced temperature is the usual laboratory convention. Allowing a cold vial to reach room temperature before opening limits condensation. Repeated opening exposes the powder to moisture and should be minimised.